.: Technetium-99 Monitoring System
- Analytical Methodology: Mini-column, Scintillation
- Limit of Detection: <900pCi/L
- Number of Sampling Ports: Four
- Sampling Frequency: Every 8 to 12 hours
- Quality Control Checks: Duplicates, Spiked Samples
- Method of Calibration: Standard Addition, Automated
- Process Control Option: Yes
- Communication Option: Wireless Communication
- Power Requirements: 110-volts, or 12-volts
- Dimensions: length: 31 ¼”, height: 21 ¾”, width: 6 ¾" (Industrial Deployment)
- Other Requirements: Source of Compressed Air (2 to 4 psi)
- Secondary parameters capable of measurement
• ion-specific electrodes
• water pressure
• water level (well levels)
The monitoring system uses a mini-column, scintillation sensor to detect Technetium-99. The sensor is composed of two types of small beads (ion-exchange and scintillation) contained within a transparent column mounted between two photo-multiplier tubes (PMTs). The cation ion-exchange beads concentrate the radiostrontium while the scintillation beads are used to convert the low energy beta particles, from the radioactive decay of the radiostrontium, to photons. The photons (ultraviolet) are detected by the PMTs. The instrument counts coincidence signals detected by the dual PMTs. PRESS ME
The wall-mounted system was designed to continuously monitor industrial and natural waters from up to four sampling ports. The system is ideal for monitoring the influent and effluent waters of treatment plants, or at points of compliance within a treatment plant. The software of the system allows the user to set the operating conditions for sampling ports to be selected, sampling frequency and when to calibrate and perform quality control checks (duplicates, matrix spikes). The system is fully automated with all calibration and quality control checks prepared and analyzed by the system. The data generated from the monitoring system is saved as either individual sample files, or the sampling results for a time period (week, month) may be collected and stored as Excel files.
The system allows and controls the introduction of the sample using either: 1) direct pressure from the industrial process, 2) peristaltic pump or 3) centrifugal pump.
The system has a process control option that allows the system to activate a relay (i.e. valve) if a user defined 99Tc concentration is exceeded.
The system has a wireless communication option allowing for a deployment of the system within industrial environments without the requirement of a communication cable.
The system maybe reconfigured for deployment at remote locations. The system can be powered by solar cells/wind turbine and wireless communications at remote locations. This configuration is used when monitoring groundwater or surface water locations.